EUROM Sani Wi-Fi 600 Mode D'emploi page 22

Figure 9
11. Place the device brackets (Figure 9, pos. 3)
over the wall bracket (Figure 9, pos. 1).
12. Slide the device (Figure 9, pos. 2) into the
openings of the wall bracket.
13. Screw and tighten the device (Figure 10, pos.
1) with a small screw (Figure 10, pos. 3) to the
wall bracket using a Phillips screwdriver
(Figure 10, pos. 2).
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 800 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
22
Figure 10