EUROM Sani Wi-Fi 600 Mode D'emploi page 21

1. Place the device on a non-flammable and
solid wall.
2. Place the device with a minimum distance
(Figure 6) of:
•
50 cm from the ceiling;
•
20 cm from the side walls;
•
10 cm from the floor;
•
50 cm clearance on the front side.
3. Do not mount the device:
•
immediately below a socket outlet;
•
on a ceiling or roof.
4. Place the wall bracket against the wall and
mark the five holes (Figure 7).
5. Drill five holes at the marked spots.
6. Place the plugs (Figure 7, pos. 3).
7. Screw and tighten the wall bracket (Figure 7,
pos. 1) to the wall with five large screws
(Figure 7, pos. 2) using a Phillips screwdriver
(Figure 7, pos.4).
8. Lay the device down on a soft steady surface
(Figure 8, pos. 4).
9. Place the two towel rails (Figure 8, pos. 3) on
two of the three possible locations on the
main body (Figure 8, pos. 5).
10. Screw and tighten the two towel rails (Figure
8, pos. 3) with eight small screws (Figure 8,
pos. 2) using a Phillips screwdriver (Figure 8,
pos. 1).
Figure 6
Figure 7
Figure 8
21