Publicité
Les langues disponibles
Les langues disponibles
3.
Remove foam strip from literature packing. Remove backing
from foam strip. Apply foam strip adhesive-side down along
MakeG
the left and right sides of the cooktop trim.
a
NOTE: The foam strip helps the cooktop sit flat on uneven
counters and avoids damage to the countertop surface.
AWARNING
ents B
Explosion Hazard
A. Cooktop base
Use a new CSA International approved gas supply line.
B. Foam strip
C. Cooktop
Install a shut-off valve.
4.
Using 2 or more people, turn cooktop right side up.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
48" (121.9 cm) 'voctl and all models
with a grill may require a
column.
_.
.
backguard. See "Cabinet Dimensions" in the "Location
Examples of a qualified person include:
Requirements" section for installation requirements. See the
licensed heating personnel,
"Tools and Parts" section for information on ordering.
authorized gas company personnel, and
Remove island trim and attach backguard using 6 screws, insert
authorized service personnel.
shown).
front and 3 from the back (9" [22.9 cm] backguard
Failure to do so can result in death,
explosion,
or fire
shown).
,
,
.
To Assemble Pressure Regulator:
1.
Using 2 or more people, stand the cooktop on its side or
back.
ae
2.
Connect the flexible stainless steel connector to the pressure
regulator using a %" male pipe thread adapter.
A combination of pipe fittings must be used to connect the
cooktop to the existing gas line. Shown following is a typical
connection. Your connection may be different, according to
the supply line type, size and location.
A. Gas pressure regulator
B. Regulator - Must be installed with arrow
pointing up to cooktop bottom
C. Adapter - Must have 12" male pipe thread
D. CSA approved flexible stainless steel gas
supply line
3.
Install the pressure regulator with the arrow pointing up
toward the bottom of the cooktop burner base and in a
position where you can reach the regulator cap.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn on the pipe
when tightening fittings.
Publicité
