Publicité
Les langues disponibles
Les langues disponibles
Install Burner Bases and Burner Caps
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
Install the burner base, making sure the igniter electrode is
properly aligned with the base. Place burner caps on top of
your cooktop.
burner bases. If burner caps are not properly positioned, surface
burners will not light.
Flame Height
20,000 Btu/h Ultra Power™ Dual-Flame Burner
A. Incorrect
B. Correct
15,000 Btu/h Professional Burner
A. Incorrect
B. Correct
The cooktop flame should be a steady blue flame approximately
¥4" (0.64 cm) high.
Dual Flame Burner
A. Upper (simmer) flame
B. Lower flame
Single Flame Burner
A. Incorrect
To Adjust Flame Height:
B. Correct
1.
Unplug cooktop or disconnect power.
2.
Remove burner grates.
3.
Remove the control knobs.
4.
Pull cooktop forward to expose the control console screws
on the side of the cooktop burner base.
5.
Remove the 2 screws on each side of the cooktop burner
base that hold the control console in place.
Electronic Ignition System
Initial lighting and gas flame adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues, until the flame is lit or the knob is turned to Off.
Check Operation of Cooktop Burners
A. Console attachment screws
Push in and turn each control knob to the "LITE" position.
6.
Disconnect wiring from the control console.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit it may take longer than
4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs
to OFF.
If burners do not light properly:
mg
Turn cooktop control knob to the "OFF" position.
m
Check that the cooktop is plugged in and the circuit breaker
has not tripped or the fuse has not blown.
m
Check that the gas shutoff valves are set to the "open"
position.
m
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
12
On Grill Models:
Support the control console in the middle with one arm and
disconnect the grill indicator light with the other hand.
A. Grill indicator light connector
Publicité
