Stihl AL 301 Notice D'emploi page 16

English
12 Troubleshooting
12.1 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being The LED fla‐
charged. shes red.
The charger The LED
does not run a glows green for
self test. about 1 second
and then red
for about
1 second.
13 Specifications
13.1 STIHL AL 301, AL 501 Charger
– Rated voltage: See rating plate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: See rating plate
For charging times, see www.stihl.com/charging-
times.
13.2 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
16
Cause
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
Electrical contact to
charger was briefly
interrupted.
13.3
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
► Do not store the battery or charger below
13.4
For optimum performance of the battery and
charger, observe the following temperature
ranges:
– Charging: 5°C to 40°C
– Storage: -20°C to +50°C
If the battery is charged or stored outside the
recommended temperature ranges, performance
may be reduced.
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
13.5
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
Remedy
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
Temperature limits
WARNING
above 50°C.
-20°C or above +70°C.
Recommended temperature
ranges
REACH
12 Troubleshooting
0458-010-9921-B