Stihl AL 301 Notice D'emploi page 15

8 Transporting
The battery and the charger warm up during
charging.
The charger has a built-in fan which may cut in
and out during the charging process.
2
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery stop glowing: The battery (2) is fully
charged and can be taken out of the charger
(3)
► If the charger (3) is no longer required. Dis‐
connect the mains plug (6) from the wall outlet
(7).
7.3 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
8 Transporting
8.1 Transporting the Charger
► Disconnect the plug from the wall outlet.
► Remove the battery.
► Wind up the connecting cable and attach it to
the charger.
► Transporting the charger in a vehicle: Secure
the charger with lashing straps, belts or a net
to prevent it turning over and moving.
9 Storing
9.1 Storing the Charger
► Disconnect the mains plug from the socket.
0458-010-9921-B
3
7
6
5
► Wind up the connecting cable and attach it to
the charger.
► Observe the following points when storing the
charger:
– Charger is out of the reach of children.
– The charger is clean and dry.
– Charger is in an enclosed space.
– The charger is not suspended from the con‐
necting cable or the holder (1) for the con‐
necting cable.
– The charger is not stored outside of the
specified temperature limits,
10 Cleaning
10.1 Cleaning the Charger
► Disconnect the mains plug from the power
supply.
► Clean the charger with a damp cloth.
► Clean vents with a paintbrush.
► Clean the charger's electrical contacts with a
paintbrush or a soft brush.
11 Maintenance and Repairs
11.1 Servicing and Repairing the
Charger
The charger cannot be serviced or repaired by
the user.
► If your charger has a malfunction or is dam‐
aged or requires servicing: Contact your
STIHL authorized dealer.
► If the connecting cable is faulty or damaged:
► If the connecting cable is pluggable:
Replace the connecting cable.
► If the connecting cable is not pluggable: Do
not use the charger and have the connect‐
ing cable replaced by a STIHL authorized
dealer.
English
1
13.3.
15