BS BATTERY BSLi-02 MAX Manuel D'instructions page 2

EN
MOTORCYCLES BATTERY MF & CHARGING INSTRUCTIONS
WARNING
Please read the instructions carefully before using the battery.
The brand could not be held responsible for the consequences of improper installation and/or misuse of the battery
inside your vehicle. If you have any problem or doubt, for your security we recommend you to contact a professional.
Instructions must be followed for a safe use of Factory Activated and Sealed Maintenance Free batteries.
Wear eye protection.
Keep children away from acid and batteries.
Explosion hazard:
- A highly-explosive oxyhydrogen gas mixture occurs when charging batteries.
Fire, sparks, naked lights and smoking are prohibited:
- Avoid causing sparks when dealing with cables and electrical equipment and beware of electrostatic discharges.
- Avoid short-circuits.
Corrosive hazard:
Battery acid is highly corrosive:
- Wear protective gloves and eye protection.
First aid:
- EYES > Immediately hold eyes open and rinse immediately with plain water for at least 15 minutes. Consult a
doctor without delay.
- SKIN > Quickly, but gently, wipe acid from skin. Remove any contaminated clothing or footwear and thoroughly
wash the affected area with soap and water for at least 15 minutes. Consult a doctor without delay.
- SWALLOWED > Do not induce vomiting. Rinse out mouth with water, and if conscious, induce copious drinking of
water or milk. Consult a doctor without delay.
Warning note:
- Do not expose batteries in direct daylight without protection.
- Discharged batteries can freeze, therefore it must be stored in an area free from frost.
Disposal:
- Take old batteries to a proper collection point.
- The instructions listed under part 1 must be followed during transportation.
- Never dispose old batteries in a domestic waste bin.
HOW TO ADD THE ELECTROLYTE
PRECAUTIONS
Always remove the battery from the vehicle.
Make sure the electrolyte is as specified for your battery.
A. PREPARING THE ELECTROLYTE
Let the battery stand on a level surface.
Remove the sealing sheet.
B. PREPARING THE ELECTROLYTE
Take the electrolyte container out of the vinyl bag. Detach
the strip cap plug from the container, which will be used as
the battery plugs later.
Note: Do not peel or pierce the sealed areas.
| www.bs-battery.com
2