Sony SDM-N50R Mode D'emploi page 17

Technical Features
Power saving function (user sensor/power saving mode)
This monitor meets the power-saving guidelines set by VESA,
or video graphics board that is DPMS (Display Power Management Signaling) compliant, the monitor will automatically enter the power
saving mode. It automatically enters the low power consumption mode when the user sensor detects the absence of a user.
Power consumption state
normal operation
1 low power consumption mode
2 power saving mode
1 (power): off
AC power: off
1 Low power consumption mode (user sensor)
When the user sensor in the monitor detects the absence of a user,
the monitor enters low power consumption mode after about 20
seconds. In low power consumption mode, the monitor is in a
power saving state and shuts off power to all circuitry (except for
that of the sensors) regardless of the setting of the computer.
The monitor returns to normal operation mode when the presence
of a user is detected by the user sensor.
When the monitor enters the power saving mode (as set according
to the computer's settings), the power saving mode takes
precedence over the low power consumption mode. In this case,
the monitor stays in the power saving mode regardless of the
presence or absence of a user.
To return the monitor to normal operation mode, reset the
computer's power saving mode.
Note
The user sensor detects the presence/absence of a user up to a distance of
approximately 60 cm from the screen surface. However, this distance may
vary depending on the user's clothes or the brightness of the surrounding
area. If user detection fails due to the ambient conditions of the
surrounding area, set the user sensor to OFF. If your monitor does not
automatically return from low power consumption mode due to the failure
of the user sensor to detect the presence of a user, press the 1 (power)
switch twice to turn the monitor off and then on.
E
NERGY
Power consumption
35 W
≤ 8 W
≤ 3 W
≤ 3 W
0 W
S
TAR, and NUTEK. If the monitor is connected to a computer
AC power indicator
green
green
orange
red
off
2 Power saving mode
DPMS defines the active off state according to the state of the
sync signals supplied from the computer. This monitor's power
consumption is input at approximately 3 W or less in this state if
the power saving function is set to ON.
When your computer enters the power saving mode, the input
signal is cut and NO INPUT SIGNAL appears on the screen.
After a few seconds, the monitor enters power saving mode.
Power saving
state
active off (deep sleep)*
* "Deep sleep" is a power saving mode defined by the Environmental
Protection Agency.
Note
The power saving function may not work normally depending on the
pattern of supplied sync signals. In such a case, set the power saving
function to OFF.
1 (power) indicator
green
green and orange alternate
orange
off
off
Sync signal state
horizontal: off / vertical: off
GB
17