Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
1
Turn off power to the electrical outlet.
2
Move the unit near the opening. Remove and recycle
packing materials.
The 76 cm model is shipped with two shipping brackets
3
located on each side, behind the front face. Remove
both brackets, then reinstall the screws. Refer to the
illustration below.
4
Plug the power cord into the grounded (earthed) outlet.
5
Position the oven in the opening and slide back until
the mounting flange is flush with the face of the cabi-
net. Avoid pinching the power cord between the unit
and cabinet wall.
6
Open the door. Using the two holes on either side of
the mounting flange as a template, drill pilot holes into
the cabinet.
7
Mount the oven using the four screws provided. Refer
to the illustration below.
8
Turn power back on to the electrical outlet.
REMOVE
BRACKETS
MOUNTING
THEN REINSTALL
SCREWS
SCREWS
Shipping brackets
Mounting screws
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Troubleshooting
IMPORTANT NOTE: If the oven does not operate properly,
follow these troubleshooting steps:
•
Verify electrical power is supplied to the oven.
•
Verify proper electrical connections.
•
If the oven does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com | 5
Publicité
