Olympus PT-036 Mode D'emploi page 42

CAUTION
1 Do not disassemble or modify this product. This may cause water
leakage or trouble. In case of disassembly or modification by persons
other than those appointed by OLYMPUS IMAGING CORP. the
guarantee shall not apply.
2 Do not place this product at locations with abnormally high or
abnormally low temperatures or at locations with extreme temperature
changes. The product may deteriorate.
3 Opening and closing at locations with much sand, dust, or dirt may
impair the waterproof characteristic and cause water leakage. This
EN
should be avoided.
4 This product has been designed and manufactured for use at a water
depth within 40 m. Please note that diving to a depth in excess of 40
m may cause permanent deformation or damage to the Case and the
camera inside the Case or may lead to water leakage.
5 Jumping into the water with the Case in your pocket or in your hand,
throwing the Case from a boat or ship into the water, and other rough
handling may cause water leakage. Please handle with sufficient care,
when handing it over from hand to hand etc.
6 If the camera on the inside should become wet because of water
leakage etc., immediately wipe off all moisture and confirm the
operation.
7 Please remove the O-ring when traveling by air. Otherwise air
pressure may make it impossible to open the Case.
8 For safe use of the digital camera in this product, please read the
"Instruction Manual" for the digital camera carefully.
9 When sealing this product, take sufficient care that no foreign matter
gets caught at the O-ring and the contact surfaces.
Batteries
Use only an Olympus lithium-ion rechargeable battery (LI-42B or
LI-40B) with the camera.
Take care that the battery electrodes do not become wet. This may
cause trouble or accidents.
Carefully read the instruction manual for the camera about other
cautions regarding batteries.
EN 4