Eaton EX RT 7/11 Manuel D'installation Et D'utilisation page 40

5. Appendices
5.2 Glossary
Backup time
Bypass AC source
ECO mode
Load
Manual bypass
Normal (double conversion) mode
Normal AC source
Relay contacts
UPS
5.3 Index
A
Automatic Bypass ............................................... 16
B
Battery ........................................6, 9, 13-14, 29, 33
Buttons .................................................................. 7
C
Cable cross-sections ........................................... 20
Circuit-breakers
Battery ............................................................ 6
Input ................................................................ 6
Upstream, downstream ................................ 20
Communication card ..................................... 11, 17
Communication ports ...................................... 6, 16
Connections
Access ............................................................ 9
AC inputs, output ..................................... 21-23
Auxiliary wires ......................................... 16-17
Battery .......................................................... 24
Communication card ..................................... 12
Isolation transformer .................................... 24
Long backup time charger ............................ 25
D
Dimensions ............................................................ 5
Display ............................................................. 7, 31
E
Emergency remote power OFF ............... 10, 16-17
Environmental ........................................................ 2
Page 38 - 34007558EN/AE
Time that the connected loads can operate on battery power.
Source supplying the bypass line. The load can be transferred to the bypass line
if an overload occurs on the UPS output, for maintenance or in the event
of a malfunction.
Operating mode by which the load is supplied directly by the AC source if it is
within the tolerances defined by the user. This mode reduces the consumption
of electrical power
Devices or systems connected to the UPS output.
Rotary switch controlled by the user, used to connect the loads directly to the
AC source. Transfer of the load to the manual bypass enables UPS maintenance
without interrupting the supply of power to the connected loads.
The normal UPS operating mode in which the AC source supplies the UPS which
in turn supplies the connected loads (after electronic double conversion).
Normal source of power for the UPS.
Contacts supplying information to the user in the form of signals.
Uninterruptible Power Supply.
I
Isolation transformer ................................ 18-19, 24
L
LEDs ...................................................................... 7
Long backup time charger (CLA) module .............. 9
M
Manual Bypass .......................................... 6, 32, 33
O
Outputs contacts ................................................. 16
P
Provided cables ................................................... 11
R
Rotate switch (bypass) .......................................... 6
S
Standards ............................................................... 2
T
Terminals
AC inputs ........................................................ 6
AC output ....................................................... 6
Auxiliaries informations ............................ 6, 16
Communication ......................................... 6, 16
Telescopic rails ......................................... 11, 14-15
Tower stands .................................................. 11-12
W
Weight ................................................................... 5