Balluff BTL7-V50D-M0500-P-C003 Notice D'utilisation page 29

BTL7-V50D-M _ _ _ _ -P-C003
Transducer in a Profile Housing
4
Installation and connection (continued)
4.3 Floating magnets
The following must be observed when installing the
magnet:
– To ensure the accuracy of the position measuring
system, the magnet is attached to the moving member
of the machine using non-magnetizable screws
(stainless steel, brass, aluminum).
– The moving member must guide the magnet on a track
parallel to the transducer.
– Ensure that the distance A between parts made of
magnetizable material and the magnet is at least
10 mm (see Figures 4-5 to 4-9).
– Maintain the following values for distance B between
the magnet and transducer and for center offset C (see
Figures 4-5 to 4-9):
Type of magnet
BTL5-P-3800-2 0.1 to 4 mm
BTL5-P-5500-2 5 to 15 mm
BTL5-P-4500-1 0.1 to 2 mm
BTL6-A-3800-2 4 to 8 mm
BTL6-A-3801-2 4 to 8 mm
The selected distance must stay constant over the entire measuring
1)
length.
For optimum measurement results, a distance B of 6 to 8 mm is
2)
recommended.
Tab. 4-2: Distance and offset for floating magnets
A A
Fig. 4-5: Dimensions and distances with BTL5-P-3800-2 magnet
A
A
Fig. 4-6: Dimensions and distances with BTL5-P-5500-2 magnet
www.balluff.com
Distance B Offset C
1)
± 2 mm
± 15 mm
± 2 mm
± 5 mm
2)
± 5 mm
2)
C
C
A A
Fig. 4-7: Dimensions and distances with BTL6-A-3800-2 magnet
A A
Fig. 4-8: Dimensions and distances with BTL6-A-3801-2 magnet
Plug with
A
A
LED
4
Fig. 4-9: Dimensions and distances with BTL5-P-4500-1
electromagnet (24 V/100 mA)
The measuring range is offset by 4 mm towards
the transducer plug (see Figure 4-9).
C
C
C
english 9