Balluff BTL7-V50D-M0500-P-C003 Notice D'utilisation page 24

BTL7-V50D-M _ _ _ _ -P-C003
Transducer in a Profile Housing
1
Notes to the user
1.1 Validity
This guide describes the construction, function and setup
options for the BTL7 Transducer with
Ethernet/IP interface. It applies to types
BTL7-V50D-M _ _ _ _ -P-C003 (see Type code
breakdown on page 17).
The guide is intended for qualified technical personnel.
Read this guide before installing and operating the
transducer.
1.2 Symbols and conventions
Individual instructions are indicated by a preceding
triangle.
► Instruction 1
Action sequences are numbered consecutively:
1. Instruction 1
2. Instruction 2
Note, tip
This symbol indicates general notes.
1.3 Scope of delivery
– BTL7 transducer
– Mounting clamps with insulating sleeves and screws
– Condensed guide
The magnets are available in various models
and must be ordered separately.
1.4 Approvals and markings
UL approval
File no.
E227256
CIP, CIP Sync, EtherNet/IP and
ODVA are registered trademarks
of ODVA.
4 english
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
The transducer meets the requirements of the following
product standards:
– EN 61326-2-3 (noise immunity and emission)
Emission tests:
– RF emission
EN 55011
Noise immunity tests:
– Static electricity (ESD)
EN 61000-4-2
– Electromagnetic fields (RFI)
EN 61000-4-3
– Electrical fast transients (burst)
EN 61000-4-4
– Surge
EN 61000-4-5
– Conducted interference induced
by high-frequency fields
EN 61000-4-6
– Magnetic fields
EN 61000-4-8
More detailed information on the guidelines,
approvals, and standards is included in the
declaration of conformity.
Severity level 3
Severity level 3
Severity level 3
Severity level 2
Severity level 3
Severity level 4