Publicité
Les langues disponibles
Les langues disponibles
8. Install hitch – Raise hitch into position by installing the forward ends of side brackets first with receiver tube angled downward. Feed the all pull wires through
mounting holes in hitch. Gently pull down on bottom edge of fascia, then rotate hitch into position. Align holes in hitch with holes in frame. Pull bolts through hitch and
into position. Remove pull wires and loosely install the conical washers and hex nuts onto carriage bolts, (4) places (2 per side). Torque fasteners to specifications below.
9. Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. ( 102 N*M)
10. Raise muffler into position - Using factory bolts reinstall exhaust hanger brackets to vehicle. Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft. ( 27 N*M).
11. Reattach Bumper Fascia – Reinstall all fasteners to Bumper Fascia removed in Step 2. Reinstall adhesive patch over access holes in bottom of frame.
©2024 Horizon Global Corporation- Printed in México
Sheet 7 of 21
76641NP
1-8-24
Rev. A
Publicité
