Publicité
Les langues disponibles
Les langues disponibles
5. Remove caulking – Using a knife scraper, remove excess caulking from outer
surfaces of frame rails so hitch bracket will sit flat against the frame.
7. Install fasteners – Feed coiled end of pull wire through existing hole on outer side of frame rail and out of Access Hole in bottom of frame, (2) per side. Attach
the 1/2" carriage bolts and 1/4" spacer blocks to pull wires and pull the fasteners inside the frame rails. Leave pull wires attached. Temporarily leave fasteners
inside the frame rails.
©2024 Horizon Global Corporation- Printed in México
6. Modify Exhaust Hangers – Using a cutting tool, remove the two prongs from
each exhaust hanger bracket.
Sheet 6 of 21
76641NP
1-8-24
Rev. A
Publicité
