Publicité
Les langues disponibles
Les langues disponibles
2b. Loosen Bumper Fascia – Using a T25 torx bit, remove (8) screws (4 per side)
from inside wheel well liner. Save fasteners for reinstall. Gently pull along bottom
edge of bumper fascia to check if it moves down freely.
Red
: Torx screw
4. Trim fascia - using a tape measure, marker, and aviation snips, measure, mark, and cut a notch in bottom center of fascia approximately 4-1/2'' tall by 3-1/2" wide
area. NOTE: Be aware of Hands-Free Antenna and wiring inside fascia. Be careful, DO NOT cut into any wiring.
Area to Trim
©2024 Horizon Global Corporation - Printed in México
3. Remove hole covers - Using a flat screwdriver, remove (2) rubber plugs from
outside of each frame rail. Remove adhesive tape from bottom rearmost access
hole each frame rail.
3-1/2"
4-1/2"
Sheet 5 of 21
76641NP
1-8-24
Rev. A
Publicité
