Publicité
Les langues disponibles
Les langues disponibles
1. Lower muffler – Using a 13mm socket, lower muffler by removing (1) bolt from each exhaust hanger, 1 per side. Save bolts for reinstall. NOTE: Use a strap to
support exhaust system before removing hangers.
2a. Loosen Bumper Fascia – Using a T30 torx bit, remove (4) screws from bottom edge of bumper fascia. Using trim tool, remove (2) Push-pin fasteners from
outer area bottom of fascia near wheel well.
Green
: Push clip
Red
: Torx screw
©2024 Horizon Global Corporation- Printed in México
Sheet 4 of 21
76641NP
1-8-24
Rev. A
Publicité
