Eaton TRIPP LITE Serie Instructions D'installation page 9

7. Fiber Splice and Mark
3
It is strongly recommended to install fibers from cable ports to the corresponding splice trays:
4
Record the parameter after splicing and making the cable marking.
5
Put the splice protect pipe clamp in the bracket and the fiber spiral storage in the splice
tray. Cover using the transparent cover or plastic cover.
Notes:
• In the process of the fiber splice and storage, the bend radius should be less than 30 mm (1.2 in.). If the
radius is too small, the fiber attenuation and the optical scatter will expand. Also, the fiber will break
eventually.
• In the process of the fiber splice and storage, take note of the twist direction. Generally, it is "8". Also, do not
break the fiber cable. After the process, place all the optical fiber below the board of the storage fiber tray.
23-04-059-9347BA.indb 9 23-04-059-9347BA.indb 9
Fusion Splicer
(Optional)
OTDR
(Optional)
9
1/3/2024 4:28:20 PM 1/3/2024 4:28:20 PM