Eaton TRIPP LITE Serie Instructions D'installation page 8

6. Installing Branch Cables
3
Attach the small port cable to the closure.
4
Secure the cable with hoop, then secure the steel core to the press patch (refer to step 3 in
the Uncut Armored Cable Installation section).
5 Press the seal gasket (liner only if necessary) and plastic washer to the small port. Screw the
M31 nut with spanner tightly to create a seal.
6
Measure the distance from the cable fixing place to the second or third tray port. Strip
the fiber tube and attach to the tray's inlet using nylon ties (refer to step 4 in the Uncut
Armored Cable Installation section)
7. Fiber Splice and Mark
1
Using a stripper, remove the cable sheath and clean it with gauze and alcohol. Then, use a
cutter to cut the fiber.
Tube Stripper
(Optional)
2
Before splicing, clean the bare fiber with clean paper. Protect the fiber with tube and secure
the fiber to the entrance of the tray with a nylon zip tie.
8
23-04-059-9347BA.indb 8 23-04-059-9347BA.indb 8
Naked Fiber Stripper
(Optional)
Fiber Cutter
(Optional)
1/3/2024 4:28:20 PM 1/3/2024 4:28:20 PM