Eaton TRIPP LITE Serie Instructions D'installation page 3

2. Cable Installation
Cable Jacket Cutter
(Optional)
Strip the cable with above tools, maintaining an appropriate length as shown in the diagrams above.
Notes:
• Make sure not to damage the optical fiber.
• Do not use a damaged optical fiber cable.
• Remove the cable jacket without cutting, kinking or damaging the internal tube.
3. Opening the Dome Closure
• Check the quantity of closure accessories.
• Place the closure on the operation table.
• To open closure for cable installation, first ensure that there is an available opening in the
base and all grommets are present.
• Next, carefully open the closure by unlatching the locking collar around the base.
Be careful as contents may be pressurized.
Unlock the locked device on the plastic hoop, open the plastic hoop to separate the cover and
base, and remove the sealing gasket.
A
Pull out the handle
Note: For good sealing performance, be careful when separating the box.
23-04-059-9347BA.indb 3 23-04-059-9347BA.indb 3
Cable Sheath Cutter
(Optional)
B
Unhook the lock
block from the lock plate
Cable Cutter
(Optional)
C
Open the hoop
1/3/2024 4:28:18 PM 1/3/2024 4:28:18 PM
3