Efco SA 2700 BP Manuel D'utilisation Et D'entretien page 10

en
10
ASSEMBLY
Tube assembly
11
WARNING – When fitting the tube and nozzle, the
engine must be off and the switch in the STOP
position.
For ease of assembly, the two pins (A, Fig.11) on the housing
and on the tubes are two different sizes. This means that the
tubes cannot be assembled incorrectly.
1. Fit the blower tube (B, Fig.14), so that the two pins (A) on
the spigot of the impeller housing engage the two slots (C)
in the blower tube. Rotate the blower tube in the direction of
12
the arrow (2). When fitted, tube should appear as shown in
Fig. 15. Secure the tube with the screw (H, Fig.15).
2. Fit the tubes in the following order: D – E – F – G (Fig. 12-13).
Engage the two slots (C, Fig. 16) on the two pins (A) of the
fitted tube. Rotate the blower tube in the direction of the
arrow (2).
NOTE: Fitting tube E – Engage the two pins (A, Fig. 17) on the
two slots (C) of the fitted tube. Rotate the blower tube in the
direction of the arrow (2).
3. After fitting the tubes, fit the 2 clips (I, Fig. 12) as shown in
Fig. 18.
4. OPTIONAL – To obtain a more directional and effective jet of
air when blowinH, the duckbill style outlet can be fitted to the
13
tube (L, Fig.13) in place of the nozzle. The kit, p/n 56552002,
can be purchased separately. To assemble, follow the
instructions of point 2.
14
15