Toto LB Serie Manuel D'installation Et D'utilisation page 5

NOTE
When mounting the wall embedded
ƒ
body, do not remove the outer plaster
guard or the inner plaster guard.
Pay attention to the embedding depth
ƒ
of the wall embedded body to ensure
that the finished wall surface is between
the marks MIN and MAX on the protec-
tive plaster guard.
Connect the inlet pipe to the wall
ƒ
embedded body. Make sure that each
connection does not leak and then ap-
ply cememnt padding.
2. Get the vapor barrier through the outer
plaster guard and use the adhesive caulk to
paste it onto the cement wall surface.
3. After the adhesive is completely
dried, fix the tile. (Ceramic tile
opening size below).
When applying adhesive between
the outer plaster guard and the
gap on the wall, make sure it is
evenly coated with silicone caulk
and that the adhesive surface is not
convex to the wall.
Ceramic tile opening size (unit: inch)
INSTALLATION PROCEDURE
Silicone caulk
Finished wall
surface
3-15.16"
(100)
Cement
wall surface
Adhesive Caulk
5
Inner Plaster
Guard
Outer Plaster
Guard
Vapor barrier