MIRKA ARP-B 300NV Instructions D'utilisation page 319

Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can be avoided by
taking proper precautions as given below.
Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback
a.
forces. Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction
during startup. The operator can control torque reactions or kickback forces, if proper precautions are taken.
b. Never place your hand near the rotating accessory. Accessory may kickback over your hand.
Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel
c.
the tool in direction opposite to the wheel s movement at the point of snagging.
Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory.
d.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or
kickback.
e. Do not attach a saw chain woodcarving blade, segmented diamond wheel with a peripheral gap greater
than 10 mm or toothed saw blade. Such blades create frequent kickback and loss of control.
Additional safety instructions for polishing operations
Safety warnings specific for polishing operations
Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck away
a.
or trim any loose attachment strings. Loose and spinning attachment strings can entangle your fingers or snag
on the workpiece.
Safety rules for battery pack and charger
Important safety and operating instructions for your battery and charger. Before using the charger, read all instructions
and warnings on the charger, the battery pack and the tool.
If the battery pack casing is cracked or damaged, do not insert into charger. There is a danger of electric shock or
electrocution.
Do not allow any liquid to get inside charger. Electric shock may result.
This charger is not intended for any uses other than charging rechargeable batteries.
Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may
result in excessive internal heat.
Make sure the cord is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
Do not use the charger if it has received a sharp blow, been dropped or otherwise damaged in any way.
Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 50 °C (122 °F).
The charger is designed to operate on standard household electrical power (100 240 VAC). Do not attempt to use it
on any other voltage.
Children should be supervised to ensure that they do not play with the appliance
Additional Safety Warnings
Always ensure that the work piece to be sanded is firmly fixed in place.
Always remove battery during any transportation of the tool.
Do not allow the tool to free speed without taking precautions to protect surrounding people and objects in the event
that the abrasive or backing pad should come loose.
Read all instructions before using this tool. All operators must be fully trained in the proper, safe use of this tool.
All maintenance must be carried out by trained personnel. For service, contact a Mirka authorized service center.
If the tool appears to malfunction, stop using it immediately and arrange for service and repair.
Before changing the abrasive always disconnect the power source
Never carry, store or leave the tool unattended with the power source connected.
Keep hands clear of the spinning pad during use.
Always wear required personal safety protection in accordance with manufacturer s instructions and local/national
standards while using this tool.
Read the Materials Safety Data Sheet (MSDS) for the working surface.
If any physical hand/wrist discomfort is experienced, stop working and seek medical attention. Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations.
Mirka® ARP-B 300NV & Mirka® AROP-B 312NV
en | us-ca
319