Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cabinet Use Requirements
Intended for use in a garage.
Maximum weight limit is 50 lbs (22.7 kg) for each shelf.
Maximum weight limit is 250 lbs (113.6 kg) for the cabinet.
Unpack Cabinet Parts
1. Remove and verify the contents. Contents include an Allen
wrench, a key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.
Assemble Cabinet
F1
⁵⁄₁₆
F1
" Allen-head bolt (24)
⁵⁄₁₆
F2
" Flange nut (24)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
³⁄₈" Wrench
Tools Supplied:
Allen wrench
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet, make sure the edges with the
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
ASSEMBLY INSTRUCTIONS
F2
Phillips screwdriver
Level
Key
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do
not tighten completely.
4. Position the other side panel (P1) so that the top (P2) is between
the edges of side panel (P1).
5. Align the holes and attach the top (P2) to the side (P1) using six
Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do not
tighten completely.
6. Insert the cabinet bottom (P3) between the edges of the side
panels (P1).
NOTE: Make sure the edges with the holes are facing up.
7. Align the holes and attach the bottom (P3) to the sides (P1) using
six Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) for each side as
shown. Do not tighten completely.
P1
P2
P2
P1
P3
P1
3
Publicité
Table des Matières
