Attach Back Panels; Install Leveling Legs - Whirlpool GLADIATOR TRÈS GRANDE ARMOIRE À OUTILS Instructions D'assemblage

Attach Back Panels

F3b Phillips-head screw (40)
IMPORTANT:
Attach the back panels (P8) starting at the top of the cabinet and
working down to the cabinet bottom. Each consecutive back
panel will overlap the panel above.
Do not completely tighten the screws until all back panels are in
place.
1. Align the first back panel (P8) with the holes in the cabinet top.
Using Phillips-head screws (F3b), attach the panel (P8) to the
cabinet top and sides.
2. Overlap the bottom of the first back panel (P8) with the top of the
second back panel (P8) as shown. Using Phillips-head screws,
fasten back panel (P8) to the cabinet sides.
A
A. Cabinet top
3. Repeat Step 2 to attach the four remaining back panels to the
cabinet sides.
4. Using two Phillips-head screws, attach each back panel to the
panel above.
NOTE: Using three Phillips-head screws, attach the last back
panel (P8) to the cabinet bottom (P3).
5. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom.
4
F3b
6. Using the Allen wrench (provided), completely tighten all 24
cabinet bolts and nuts.
P1
P3
A. Cabinet bottom

Install Leveling Legs

1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P3
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already done so, fasten the two bolts at each
front corner, of the cabinet frame. Completely tighten all the
cabinet bolts and nuts.
P2
P1
A
P4
A