Install Shelves; Install Doors; Complete Assembly; Accessories - Whirlpool GLADIATOR TRÈS GRANDE ARMOIRE À OUTILS Instructions D'assemblage

Install Shelves

F3b
F3b Phillips-head screw (12)
F4 Small flange nut (12)
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf (P5), so the doors will lock. The
other two shelves may be installed where desired.
1. Place a shelf (P5) so that the holes in the ends are aligned with
the pair of holes in the middle of the cabinet sides.
NOTE: Make sure the holes in the long edge of the shelf are
facing out.
2. Using two bolts and nuts per side, fasten the shelf (P5) to the
sides (P1).
P1
A
A. Middle pair of holes in cabinet side
3. Determine where you want to place the other two shelves (P5).
Align the holes in the shelf ends with the holes in the cabinet
side.
NOTE: Make sure the magnets on the long edge of the shelf are
facing the cabinet front.
4. Using two bolts and nuts per side, fasten the shelves (P5) to the
cabinet sides (P1). Completely tighten the nuts.
F4
P2
P1
P5
P3

Install Doors

F3b Phillips-head screw (12)
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3b) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle four screws through the door hinge into the
cabinet and hand tighten.
P2
P5
P1
P5
A
P5
P3
A. Phillips-head screws
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the screws.

Complete Assembly

1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.

ACCESSORIES

To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator
GarageWorks dealer. In Canada, call 1-800-807-6777.
Mounting Bracket Kit - Allows the cabinet to be mounted on
Gladiator ® Garageworks GearWall
Order Part # GABK362PSS
F3b
P7
® panels or GearTrack ® channels.
®
5