Cabinet/Locker Safety; Assembly Instructions; Cabinet Use Requirements; Unpack Cabinet Parts - Whirlpool GLADIATOR Série Instructions D'assemblage

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

Cabinet Use Requirements

Intended for use in a garage.
Maximum weight limit is 40 lbs (18 kg) for each shelf.
Maximum weight limit is 150 lbs (68 kg) for the cabinet.

Unpack Cabinet Parts

1. Remove and verify the contents. Contents include an hex key
and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.

Assemble Cabinet Frame

F1 ⁵⁄₁₆ " Hex-head bolt (16)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
Tools Supplied:
Hex key
IMPORTANT:
Two people may be required to complete the assembly.
The cabinet top (P2) is intentionally designed so that the tabs will
only match with the loops on the sides when it is positioned
correctly. If the tabs on the cabinet top do not match up with the
loops on the side panel (P1), turn the cabinet top around.

CABINET/LOCKER SAFETY

Your safety and the safety of others are very important.

ASSEMBLY INSTRUCTIONS

F1
Phillips screwdriver
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the loops is facing up.
2. Align the tabs in the cabinet top (P2) with the loops in the cabinet
side (P1). Slide the cabinet top between the edges of side panel.
NOTE: Make sure each tab is inserted fully behind the loop.
P2
A
3. Align the two holes in each corner. Using hex-head bolts (F1),
fasten the side panel (P1) to the top (P2) as shown. Do not
tighten completely.
4. Repeat steps 2 and 3 for the other cabinet side (P1).
5. With the smooth side toward the cabinet interior, align the four
tabs in the cabinet bottom (P3) with the loops in the cabinet
sides (P1). Slide the cabinet bottom between the edges of side
panels.
NOTE: Make sure each tab is fully inserted behind the loop.
P2
B
P1
A. Tab
B. Loop
3