Husqvarna 55 Rancher Manuel De L'opérateur page 35

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96
Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar
Length, inches Pitch, inch Max nose radius
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
15 0,325
16 0,325
18 0,325
20 0,325
18 3/8
20 3/8
16 3/8
18 3/8
20 3/8
24 3/8
0,050"/1,3 mm H30/95VP
-
0,058"/1,5mm -
H42
TECHNICAL DATA
Chain
10T Husqvarna H30, Oregon 95VP
10T
10T
10T
10T
10T Husqvarna H21 / H25 / S24, Oregon 21LP / 21BP / 34LG / 34SL
10T
10T
10T
11T Husqvarna H81, Oregon 73V
11T
11T Husqvarna H42 / S48, Oregon 73LP / 73LG / 77S
11T
11T
11T
- - 20LP
H80 - 72LP
H25,H21 S24 21LP
H81 S48 73LP
1
5
20BP 33LG 33SL
72LG 76SL 72V
21BP 34LG 34SL
73LG 77SL 73V
L
– 35
Canadian