Makita DRV250 Manuel D'instructions page 9

clockwise. To install the mandrel container, rotate it
clockwise.
OPERATION
CAUTION:
Keep your hand and face away
from the front part of the tool. The rivet or broken
off mandrel may accidentally ejected, and you may
be injured.
Installing a blind rivet
CAUTION:
Before the mandrel container
becomes full, empty it regularly by removing the
mandrel container. Otherwise, the tool may be dam-
aged, and the damaged parts may cause an injury.
CAUTION:
When inserting a blind rivet into
the nose piece, be sure to switch off the tool.
Otherwise, you may be injured with the tool tip.
CAUTION:
Do not the leave a blind rivet in the
nose piece. If the tool is switched on accidentally, the
blind rivet is ejected and may cause an injury.
Available blind rivets
Optional accessory
NOTICE:
Using nose piece, jaw, jaw pusher, or pipe that does not match the mandrel diameter may cause
poor fastening, clogging of the mandrel, or malfunction of the tool.
Refer to the table below for the combination of rivet, nose piece, jaw, jaw pusher, and pipe.
NOTE: Some items in the table may be included in the tool package as standard accessories and some items in
the table are provided as optional accessories. They may differ from country to country.
For DRV150
Rivet
Size Diameter
of mandrel
ø2.4 mm ø1.4 -
(3/32") 1.6 mm
ø3.2 mm ø1.8 -
(1/8") 2.1 mm
ø4.0 mm ø2.2 -
(5/32") 2.6 mm
ø4.8 mm ø2.6 -
(3/16") 3.2 mm
*1. Pipe is not necessary for operation.
*2. Including nose piece, jaw pusher, and pipe.
*3. Proper jaws for rivet ø4.8 mm (3/16") are different from DRV250.
Nose Jaw pusher
piece
Mark Hole
on nose diameter
piece
24S ø1.9 mm Gray
32S ø2.5 mm Black
40S ø3.1 mm Gray
48S ø3.6 mm Black
► Fig.11: 1. Mandrel container
NOTICE:
After installing a blind rivet, be sure
to eject the broken off mandrel into the mandrel
container by tilting the tool backward before
installing next blind rivet. If the end of the broken
off mandrel sticks out from the nose piece, switch
off the tool and remove the mandrel. Otherwise,
the broken off mandrels may become clogged and
cause a malfunction of the tool.
1.
Insert the blind rivet into the nose piece.
► Fig.12: 1. Blind rivet 2. Nose piece
2. Press the tool tip against the workpiece, and then
pull the switch trigger. After the mandrel is broken off,
release the switch trigger.
► Fig.13
Before the mandrel container becomes full, empty it
regularly by removing the mandrel container.
Pipe
Color Hole Color
diameter
ø2.2 mm Silver
ø2.6 mm Black
None *1
None *1
9 ENGLISH
Part
number of
accessory
Mark
set *2
on Jaw
1911U6-3 4.8
1911U4-7
– 1911U1-3
– 1911T9-0 6.4 *3
Jaws
Part
number
199731-7
199730-9