Publicité
Les langues disponibles
Les langues disponibles
2.
Clean the appliance with a moist cloth and some
detergent.
Troubleshooting
Problem
You cannot activate or operate the
appliance.
The residual heat indicator does not
come on.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Installation
Warning! Refer to the Safety chapters.
Before the installation, note down the serial
number (Ser. Nr.) from the rating plate.The rating
plate of the appliance is on its lower casing.
KEV6140FBB
220-240 V 50-60 Hz
58 PEE 11 AO
ZANKER
3.
Possible cause
The appliance is not connected to
an electrical supply or it is connec-
ted incorrectly.
Problem with the house electrical
system.
The cooking zone is not hot be-
cause it operated only for a short
time.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Built-in appliances
• Only use the built-in appliances after you assemble
Connection cable
• The appliance is supplied with the connection cable.
949 594 301 00
• Replace the damaged mains cable with a special ca-
6 kW
At the end rub the appliance dry with a clean
cloth.
Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electrician.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
the appliance into correct built-in units and work sur-
faces that align to the standards.
ble (type H05BB-F Tmax 90°C; or higher). Speak to
your local Service Centre.
Remedy
15
Publicité
