Battery Charge - TXED BIKE E POWER PRO XV 27.5+ Mode D'emploi Et D'entretien

3. When the above assembly finish, lift the battery above the frame down tube, aligned position of battery
slides then put the battery case inside the slot, ensure a snug fit, then lock it tightly. Fixing the battery well,
use the key to lock the battery with slide. (Fig 3.1~3.3)
(Fig 3.1)
(Fig 3.3)
4. Refer to the battery lock and unlock, see the following pictures
for reference.
From the initial position 12 o'clock (where the battery and tube are
locked), insert the key into the key slot, and turn it clockwise to
position 3 o'clock (Then the battery is unlocked).
On the contrary, you can unlock it.

5. Battery charge

If an AC outlet is available within reach of your electrical bicycle, you can charge your bike directly, while
the battery needn't take out. The charging port is covered by a plastic cap (Fig 4.3). Please open it then you
will find two ports, the left round one is for charge directly (Fig 4.4). The right one is originally design for
USB, but it wastes the power greatly, so now although it exist, but actually it cannot be used, please neglect
it.
Removing the battery is useful for charging in a location where the electrical bicycle may not fit or when
no reachable AC power supply exists at the place where the electrical bicycle is parked
Before removing the battery from the electrical bicycle, you need to unlock as following steps:
(Fig 3.4)
(Fig 3.2)
(Fig.3.4)
27/55