Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. Maintaining the Controller.
For our electrical bicycle the controller is usually equipped inside the battery pack holder.
It is very important to take care of this electronic component, according to the following guideline:
9.1 Pay attention to protect from ingress of water and immersion in water, which may damage the
controller. Note: If you think water may have got into the control box, please switch off the power
immediately and pedal without electric assistance. You can pedal with electric assistance as soon as the
controller has dried out.
9.2
Pay attention to protect from any strong shaking and punching, which may damage this controller
9.3
The controller should be used in normal working temperature range from -15°C to +40°C
Warning:
or adjust the controller will void the warranty. Please ask your local dealer or authorized service specialist
to repair your electrical bicycle.
10. Maintaining the Power-off Control of the Brake Lever*
This is a very important component for riding with safety. First, you should pay attention to protect it from
impact and avoid any damage. Second, make regular check on all bolts and nuts, and fasten them securely.
11. Simple Trouble shooting.
The information below is for purpose of explanation, not as a recommendation for user to carry out repair.
Any remedy outlined must be carried out by a competent person who is aware of the safety issues and
sufficiently familiar with electrical maintenance.
Trouble Description
After the main battery
switched on, the motor
does not generate
assistance when
pedaling.
Do not open the controller box. Any attempt to open the controller box, modify
Possible Causes
1)the motor cable (waterproof
connection joint) is loose; 2)brake
lever did not return well, which keeps
the switch in "power off" position;
3)battery fuse is broken; 4) the speed
sensor
is too far away from the magnetic
ring on the B.B.axle; 5) the
connection between the sensor and
the controller is loosen or not
connected well.
Trouble shooting
First of all, please check the battery if it is
empty. If yes, charge the battery immediately.
1) check if the connection is securely fixed. If
loose, joint them tightly. 2) make the brake
lever come back to its normal position with
care, without braking; 3) open the battery
pack top, and check if the fuse is broken. If
yes, please visit your vendor or authorized
service for installing a new fuse; 4) adjusting
the distance between the magnetic ring and
the sensor, to make sure the distance is within
3mm ; 5) fix tight the connection between the
sensor and the controller.
34/55
Publicité
Table des Matières
