Suntec Wellness Klimatronic COOLFIXX 3.5 Eco R290 APP Mode D'emploi page 16

5. SLEEP MODE (8): Switch the unit into the cooling (or heating) mode and press this button to de- or activate
the sleep mode.
6. TIMER (2): Turn the unit on and leave it in standby mode, then press this button to set the timer. You can set
the desired on or off time using the ▲ and ▼ keys (1h-24h).
7. SWING (1): Please press these buttons to activate the automatic swing movement.
Remote control
1. Power
2. Timer
3. Mode
4. Temperature +
5. Temperature -
6. Fan
7. Sleep mode
8. Swing
Functions
Cooling mode/ heating mode
Press the MODE button to set the cooling/heating mode, the cooling/heating mode indicator lights.
•
Press the + or - to adjust to the temperature (7°C – 35°C).
•
Press the FAN button to adjust the fan speed (high or low).
•
Fan mode
Press MODE button to turn on the fan mode, the fan mode indicator lights.
•
Press the FAN button to adjust the fan speed (high or low).
•
Temperature setting and sleep mode cannot be set.
•
Timer
In standby mode, press the TIMER button to set the on-time. The timer indicator lights up.
•
After starting the unit press the TIMER button to set the off-time. The timer indicator goes off.
•
Dehumidifying mode
Drücken Sie die Taste MODE, um den Entfeuchtungsmodus einzustellen, der Entfeuchtungsmodus-
•
Indikator leuchtet.
• Temperatureinstellung und Schlafmodus können nicht eingestellt werden, die Geschwindigkeit des
Ventilators bleibt automatisch niedrig.
Sleep mode
• Press the SLEEP MODE button, the fan speed will be automatically adjusted on the low level.
After 1 hour the preset temperature is automatically increased by 1 ℃, after another hour the preset
- In Cooling Mode:
temperature is automatically increased again by 1 ℃.
•
After 1 hour, the preset temperature is automatically reduced by 1 ℃, after another hour, the preset
- In Heating Mode:
temperature is reduced again by 1 ℃.
•
Sleep mode is not adjustable during dehumidifying and fan mode. If the water tank is full, the standby
•
mode will switch on, settings will be deleted and the sleep mode will be disable.
Compressor protection
The compressor requires a start-up phase and will start three minutes later on after turning on / reboot
•
the device.