Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the transport pallet on which your
wine cellar rests.
2.
Adjust the feet to allow a 30 mm (1.2")
clearance under the wine cellar. Make sure
the wine cellar stands in a vertical position
in both directions. (Use a spirit level if
necessary.)
3.
Check that the charcoal filter is in place at
the top left corner inside the wine cellar.
ElEctrical connEction
It is essential that the electrical installation is car-
ried out correctly, taking into account all relevant
regulations and codes of practice.
U.S
If an external electrical source is utilized, the wine
cellar, when installed, must be electrically ground-
ed in accordance with local codes or, in the absence
of local codes, the National Electrical Code, ANSI/
NFPA 70 - (latest edition).
Canada
If an external electrical source is utilized, the wine
cellar, when installed, must be electrically ground-
ed in accordance with local codes or, in the absence
of local codes, the Canadian Electrical Code, CSA
C22.1, Parts I and II - (latest edition).
Your wine cellar will operate on a mono-phased
alternating current.
Please check that the voltage shown on the data
plate corresponds to your power supply.
The wine cellar is fitted with a plug intended for an
grounded socket. Dometic and its subsidiaries will
not be held responsible for any incident due to non-
existent or defective ground wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp parts of the wine cellar.
6
Warning
!
the wine cellar must be grounded.
tEmpEraturE sEtting
The wine cellar is equipped with an electronic
regulator. This allows you to programme the tem-
perature inside the wine cellar. Your wine will
then be stored between 10 °C (50 °F) and
15 °C (59 °F) according to expert advice. The tem-
perature is shown on the display. The temperature,
pre-set at 12 °C (54 °F), can be changed according
to the wine stored.
1.
Plug in the wine cellar and turn it on with
the switch.
2.
Press and hold the UP
arrow button for a few seconds until the
display starts blinking.
3.
Release the button. Press the UP/DOWN
arrow buttons to set the temperature.
The new value is saved automatically after
6 seconds.
It is important to avoid rapid tempera-
ture changes inside your wine cellar!
A certain smell may be noticeable when
using the wine cellar for the first time.
This will disappear after a few hours.
maintEnancE
We recommend that you keep your wine cellar as
clean as possible. Unplug the cellar before clean-
ing. Do not use any abrasive or strong scented
substances. Use a smooth cloth or sponge and light
detergent.
It is very important to check regularly that the air
circulation underneath and behind the cellar is
not blocked. Condensation collects in a small cup
placed at the back of the wine cellar. The cup has a
sponge which helps the condensation to evaporate.
Check that the plastic pipe routing the water from
the inside to the cup is not blocked by dust or dirt.
- 7 -
(
)
(
)
or DOWN
▲
▼
Publicité
