Publicité
Les langues disponibles
Les langues disponibles
This dryer is supplied/fitted with an electricity supply cord and
Using the universal cord included with this dryer:
plug. It should be connected to electricity supply socket at the
Th
d
.
'oped
with
.
|
cord
with
voltage shown on the rating plate. The minimum supply fuse
ine gas
aryer is equipped
with
4 universal Cord wi
capacity should be 5A. The dryer must be positioned so that the
interchangeable plugs.
plug is clearly visible and accessible. This plug also provides the
4. To use the universal cord, select the plug end that fits
function of an emergency stop control for the user. If the fitted
your electrical outlet, and plug it into the adapter on the
plug is not used, the electrical connection must be carried out
,
by a competent electrician in accordance with local or national
supply cord,
codes.
2. Secure the plug end in place on the cord by aligning
if the supply cord is damaged, it must be replaced with a
the 2 cover halves over the cord adapter and clipping
specially terminated cord by an authorized service agent or
them together.
a similarly competent person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive
(2004/1 08/EC), the maximum electricity supply system
impedance to which the gas dryer should be connected
is declared to be 0.054 Ohm + j0.084 Ohm.
NOTE: Electrical safety standards: The manufacturer has
chosen compliance with IEC/EN.60335 standards as the most
appropriate for this product.
°
Electric Shock Hazard
This is a 3-wire appliance which must be earthed.
AWARNING
Do not earth to a gas pipe.
Do not change the power supply cord plug. If it does
not fit the outlet, have a proper outlet installed by a
qualified electrician.
Do not use an extension cord with this dryer.
Failure to follow these instructions could result in
Explosion Hazard
death, fire, or serious injury.
Connect this dryer to a regulated gas supply. Supply
pressure must be in accordance with the Technical
Specifications (see last page).
if codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
Install a shut-off valve.
bond
path I s
ad
te.
One
Pain
IS ace quare
Securely tighten all gas connections.
EARTHING
INSTRUCTIONS
lf connected to LP, have a qualified person make sure
gas pressure is correct.
@ For an earthed cord-connected dryer:
Failure to do so can result in death, explosion, or fire.
This dryer must be earthed. In the event of a malfunction or
breakdown, earthing will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This dryer is equipped with a cord having an equipment-
earthing conductor and a earthing plug. The plug must be
IMPORTANT: Observe all governing codes and ordinances.
plugged into an appropriate outlet that is properly installed
Gas Supply
and earthed in accordance with all local codes and
ordinances.
Before installation, check that the local gas distribution
WARNING:
improper connection of the equipment
conditions, nature of gas and pressure, and the adjustment
earthing conductor can result in a risk of electric shock.
of the appliance are compatible. Burner information will be
Check with a qualified electrician or service representative
found on the model/serial rating plate in the door recess of
or
personnel
if you
are
in
doubt
as
to
whether
the
dryer
the
dryer.
If this
Information
does
not
agree
with
the
type
is properly earthed. Do not modify the plug provided
of gas available, see your dealer.
with the dryer: if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
SAVE THESE INSTRUCTIONS
Publicité
