Maytag Commercial Laundry MDG25PN Instructions D'installation page 4

DRYER DISPOSAL
(WEEE).
electronic equipment.
This appliance is marked according to the European directive 2002/ 96/ EC on Waste Electrical and Electronic Equipment
By ensuring this product is disposed of correctly, you will help avoid potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated
as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and
Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
@ 200 mm (8") or 250 mm
(10") Pipe wrench
@ 200 mm (8") or 250 mm
(10") Adjustable wrench
@ Flat-blade screwdriver
8 mm (5/16") socket wrench
Utility knife
Vent clamps
Pipe-joint compound
resistant to LP gas
@ Phillips screwdriver Sealing gun and sealing
@ Adjustable wrench that compound (for installing
opens to 25 mm (1") or new exhaust vent)
hex-head socket wrench
Pliers
w Level
m Stiff-bladed putty knife
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
@ Foot boot (4)
@ Dryer foot (4)
@ PD models: Cam for
service door lock
@ PN models: Card reader
bezel, card reader wire
harness, hardware
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.
AWARNING
Explosion Hazard
Keep flammable materials and vapors, such as petrol,
away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire.
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
™@ Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
™ Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" below
for minimum spacing requirements.
@ Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.