Publicité
Les langues disponibles
Les langues disponibles
ELECTRONIC CONTROL SETUP
AWARNING
Electric Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD is present everywhere. ESD may damage or weaken the
electronic control assembly. The new control assembly may
appear to work well after repair is finisned, but failure may
occur at a later date due to ESD stress.
@ Use an anti-static wrist strap. Connect wrist strap to green
earth connection point or unpainted metal in the appliance.
-~OR-
Touch your finger repeatedly to a green earth connection point
or unpainted metal in the appliance.
@ Before removing the part from its package, touch the
anti-static bag to a green earth connection point or
unpainted metal in the appliance.
@ Avoid touching electronic parts or terminal contacts; handie
electronic control assembly by edges only.
@ When repackaging failed electronic control assembly in
anti-static bag, observe above instructions.
GENERAL
USER INFORMATION
"out of order" showing in display
This condition indicates the dryer is inoperative. Diagnostic or failure
code will follow the scrolling message.
"0 Minutes" showing in display
This condition indicates the dryer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored by
opening and closing the door. If a door switch fails, it must be
replaced before normal operation can be restored.
Cold Start (initial first use)
Dryer is programmed at the factory as follows:
@ 45 minutes dry time for PN models; 5 minutes per coin for
PD models.
@ 1.50 dry price (fixed cycle with top off - PD Models).
@ 0.00 dry price (fixed cycle - PN Models).
Warm Start (after power failure)
A few seconds after power is restored, if a cycle was in progress
at the time of the power failure, "RESELECT CYCLE" will flash
in the display. This is to indicate the need for a fabric setting
button to be pressed to restart dryer.
Pricing
After the door is opened and closed following the completion of
a cycle, the display indicates the cycle price (unless set for free
operation). As coins or debit inputs arrive, the display will change
to lead the user through the initiation of a cycle.
There are four (4) types of pricing:
Fixed "Vend" Pricing
A aryer set up for "Fixed Cycle" operation can only accept
additional time accumulated by increments equal to the length of a
complete dry cycle. A maximum of 99 minutes may be purchased;
no additional credit is given when 99 minutes is in the display.
Accumulator Pricing
if the price is set to one coin 1, then accumulator mode is in effect.
Cycle time can be purchased one coin at a time (PD models) up to
the maximum time of 99 minutes.
Fixed Cycle With Top Off Pricing
A aryer set to offer "Top Off' capability will allow time to be added
to an existing dry cycle in increments equal to the number of
minutes of dry time per coin (coin 1), up to 99 minutes, regardless
of the cost required to start the dryer. No credit is given for coins
or debit inputs entered when the control is displaying 99 minutes.
PN Models Set Up As PR: In Enhanced Debit Mode, the top off
price can be set independently (see VALUE OF COIN 2), and the top
off time is calculated according to the following equation:
top off price
full cycle price
top off time
full cycle length
Hundrecth increment offset is not applied to top off purchases.
PN Models
The factory has preset the cycle price to zero. When this happens,
"SELECT CYCLE" will appear rather than a cycle price. Any cycle
started as a free cycle will automatically terminate when the door
is opened.
Debit Card Ready
This dryer has a control that is debit card ready, but the dryer is not.
13
Publicité
