AEG GS55AI220 Notice D'utilisation page 76

76 www.aeg.com
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
Activating the rinse aid
dispenser with the multitab
option activated
1. Press the on/off button to activate the
appliance. Make sure that the appli-
TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (8) and (9) at
the same time until the programme in-
dicators above buttons (8), (9) and (10)
flash.
3. Press button (9) .
• The programme indicators above
buttons (8) and (10) go off.
• The programme indicator above
button (9) continues to flash.
• The display shows the setting of the
rinse aid dispenser.
4. Press button (9) to change the setting.
5. Deactivate the appliance to confirm.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
(0.5 / 0.05 ) / (8 / 0.8 )
2)
Off
On
546 / 759 / 571
220-240 V
50 Hz
max. 60 °C
12
0.10 W
0.10 W