Publicité
Les langues disponibles
Les langues disponibles
6. Position the air control ring at the 12 mm (0.47 inch.) position and screw home again.
7. Replace and screw in the base of the appliance. It is advisable to make note of the new
configuration on the manufacturer's rating plate on the base of the appliance and erase the old
one.
8. Put the replaced jet in the conversion pack and keep in a safe place, then turn to the setting up
procedure.
The slow setting (FIG 5)
When the appliances are adjusted for Propane gas, the screw for slow setting is turned completely
to the right. If you change from propane gas to natural gas, you must undo this screw until you
obtain correct adjustment of the slow setting. The slow setting is correctly adjusted when, if you go
rapidly from maximum to minimum position, the flame does not go out. The flame should be as
low as possible, approximately the equivalent of half a pin head over each hole.
To adjust the slow setting, the griddle should be in place.
1. Light the burner and heat on maximum for 2 to 3 minutes.
2. Turn the knob to position 1 (or adjust the knob to the low flame setting)
3. Remove the knob by pulling it towards you. Take care not to lose the steel blade located inside.
4. The adjustment screw located on the side of the tap or thermostat shaft can be reached using a
small screwdriver.
5. Watching the flame beneath the griddle, unscrew to increase the slow setting, tighten the
screw to decrease it. (See chart page 6).
6. Replace the knob taking care to place the flat parts flush to each other.
Piezo ignition plug (FIG 3)
For good ignition of the burner, it is imperative for the spark plug (FIG 3 rep. 9) to be positioned in
line with the following measurement: B = 3 mm (0.12 in.) above the safety thermocouple
Safety thermocouple (FIG 3)
In order for the safety thermocouple to operate correctly, the pin located in the flame (FIG 1 mark
1) must always be placed exactly at the following position: A = 27 mm (1.06 in.).
- 23 -
Publicité
