Publicité
Les langues disponibles
Les langues disponibles
▪ NOTICE: In order to be able to operate and service this appliance, it must be installed with a
connector complying with ANSI Z21.69 – CSA 6.16 and a quick disconnect device complying
with ANSI Z21.41 – CSA 6.9. It must also be installed with restraining means to guard against
transmission of strain to the connector as specified in the appliance manufacturer's instructions.
Clearances to combustible construction
Counter top mounting (FIG 6 page 4)
- Single burner versions: 8 in. clearance to sides and rear
- Double burner versions: 8 in. clearance to sides, 12 in. to rear.
Using
Ignition
1. Once the appliance has been fully installed ready to operate, check that the gas supply tap is
open.
2. When igniting for the first time after installation, push in the knob, place it on the maximum
setting and hold it pressed in for 5 seconds to allow the air in the gas pipe to the burner to
escape. Then release the knob.
3. Then set the knob to position 5.
4. Use the piezo ignition unit, then push the knob without changing its position until the burner
has ignited completely.
5. Continue holding the knob in for between 5 and 10 seconds to trigger the thermocouple
system.
6. Then release the knob and let the burner heat up for 3 to 4 minutes, before adjusting the knob
to position 1 (slow setting).
7. Your appliance is now ready to use.
8. Set the burner to slow setting if you are not working immediately.
9. To shut off appliance turn knobs to "zero" position.
10. Wait 5 minute complete shutoff period prior to relight.
Seasoning of the griddles
The surfaced cast iron griddles need seasoning before using for the first time. Use the cleaning pad
ATE1 for this operation.
Caution: this operation (lasting 1 to 1 ½ hour) is necessary when griddles are new.
Use sunflower frying oil without other ingredient.
Once your appliance is connected to the gas supply and the griddle plate is in position, proceed as
follows.
- 19 -
Publicité
