Publicité
Les langues disponibles
Les langues disponibles
The appliance should be connected to the gas supply with a flexible tube in accordance with
current standards and regulations. Before using your appliance, please refer to the following
indications:
Technical datas chart page 3,
▪
Appliances drawings page 4,
▪
Connecting advices page 17,
▪
Chapter "Adjusting" page 21, before changing any settings of the appliance.
▪
FOR YOUR SAFETY: do not store or use gasoline or other flame vapors or liquids in the
vicinity of this or any other appliance.
WARNING: improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operating and maintenance
instructions thoroughly before installing or servicing this equipment.
Work surface
Choose an easy-to-clean work surface on which to install the appliance. The appliance must be at
least 20 cm (7.9 in.) from any vertical surfaces that are not heat-resistant in order to prevent
damage by heat radiating from the plates. To ensure maximum ease of use, the top of the irons
should be between 85 and 95 cm from the ground (33.5 to 37.4 in.).
Connecting
The configuration for the gas supply to the appliance is indicated on the identification plate stuck
to the air intake ring or the base plate.
If you need to change the gas configuration of your appliance, please refer to the "Adjusting"
chapter page 21 (bag attached containing items required for the change-over)
▪ Installation must conform to local codes, or in absence of local codes, with National Fuel
Gas Code, ANSI Z223.1/NFPA 54, or the National Gas and Propane Installation Code, CSA
B149.1, as applicable.
▪ The appliance and its individual shutoff valve must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressures in excess of ½
psi (3.5 kpa).
▪ The appliance must be isolated from the gas supply piping system at test pressures equal
to or less than ½ psi (3.5 kpa).
▪ For the maintenance and repairs, contact the factory, representative, or local service
company.
▪ This appliance employs a chain restraint. If the chain restraint is required to be removed
for any purpose, it must be reconnected after returning the appliance to its originally
installed position.
Important safeguards
▪ Wait a 5-minute complete shutoff period prior to relight.
▪ WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death.
instructions thoroughly before installing or servicing this equipment.
Read the installation, operating and maintenance
- 18 -
Publicité
