Publicité
Les langues disponibles
Les langues disponibles
CAREFUL: never suddenly cool plates.
Preparing crepes requires a contribution of fat on the griddle.
- Lubricating
- Fat in the batter according to recipes
These fats will gradually thicken the initial seasoning. Avoid seasoning that does become too thick
because:
- It acts as an insulator and interferes with the cooking.
- It is flaking off or giving the impression that the metal disintegrates.
Therefore the strip regularly uses the abrasive stone APA1 Krampouz.
If the seasoning is too thick default regular stripping, it is possible stripping plate by blasting
(contact our customer service).
After these operations must be redone a seasoning as for a new product.
The burner
Occasionally check the state of the burner outlet holes. If they are blocked, brush the branches with
a hard-bristle brush. Before using again, carefully wipe the burner as well as the bottom of the
combustion chamber.
Be careful: models with a safety thermostat from the LUXURY range: the griddle is fixed to the
frame. If you require access to the burner, take care not to damage the probe fixed under the
griddle.
Storage
We advise you to store your appliance in a dry and clean place.
Adjusting
Reminder: our appliance adjusting must be made by technicians and installers properly
qualified for gas installations.
If the type of gas supply needs changing it is essential to replace the jets, to reset the air intake to
12 mm (0.47 in.) and to adjust the slow setting.
Refer to datas page 3 and drawings of appliances details page 4.
Replacing the burner jets
If the appliance is already installed, before proceeding with replacement of the burner jets or any
new adjusting, ensure that the gas supply is switched off (whether mains gas or gas cylinder).
Then proceed with the following operations:
1. Turn the appliance over.
2. Remove the base of the appliance by unscrewing the feet on round appliances with a base
plate, and by removing the screws on square appliances.
3. Open the air inlet as wide as possible by sliding back the ring which regulates air (FIG 4 rep 11).
4. Unscrew the jet (FIG 4 rep. 12) with a 10 mm spanner; take the conversion pack.
5. Change the jet and its washer, following the information given in the reference chart showing
jet diameters and various types of gas supply. (chart page 3).
- 22 -
Publicité
