Publicité
Les langues disponibles
Les langues disponibles
®
induQ
- Series VMI
IMPORTANT!
Use the type plate to check if the delivered unit corresponds to your order.
In particular, for devices with electrical components, check to see if the correct power
supply voltage is specified.
Accessories:
Connection cable with moulded M12x1 coupling
socket.
M12x1 coupling socket as component.
1.2 Intended use
The magnetic inductive flow sensor VMI must only be used for measuring and metering liq-
uids with a minimum conductivity of 50 μS/cm.
WARNING! No safety component!
The magnetic inductive flow sensor of the series VMI is not safety components in accord-
ance with Directive 2006-42-EC (Machine Directive).
Never use the VMI as a safety component.
The operational safety of the device supplied is only guaranteed by intended use. The speci-
fied limits ( § 9 "Technical data") may under no circumstances be exceeded.
Before installing the device, check that the wetted materials of the device are compatible
with the media being used ( § 9.2 "Materials table").
Measuring tube empty (or partially filled). / Conductivity too low.
The green LED may blink irregularly if the measuring tube of the VMI is empty or partial-
ly filled or if the conductivity of the fluid being used is too low. Random pulses will be
present at the output, but they do not represent an actual flow.
Ensure that the measuring tube of the VMI is always completely filled ( § 4.1
"Installation instructions").
Ensure that the conductivity of the fluid is at least 50 μS/cm.
1.3 Exclusion of liability
We accept no liability for any damage or malfunctions resulting from incorrect installation,
in-appropriate use of the device or failure to follow the instructions in this operating manual.
Technical changes reserved
Device description
- 25 -
Publicité
