SIKA VMI Serie Notice D'utilisation page 24

Device description
1 Device description
®
induQ
The of the VMI series from SIKA, is a non-contact flow sensor. The measurement is
performed using magnetic induction and works without any moving parts.
The VMI is used for measuring or metering water and aqueous solutions. The compact design
and independence from the intake and discharge sections allows the VMI to be used under a
variety of conditions.
∗
Versions :
The VMI is available in nominal sizes DN 7, DN 10 and
DN 20.
The versions can be configured differently. Further infor-
mation can be found in our catalogues at
logues.sika.net.
Type plate:
The type plate sticker is located at the bottom side of the
VMI.
It contains the most important data, the connection diagram
and the arrow for the flow direction (example  Fig.).
1.1 Delivery, unpacking and accessories
All units have been carefully checked for their operational reliability before shipment.
 Immediately after receipt, please check the outer packaging for damages or any signs of
improper handling.
 Report any possible damages to the forwarder and your responsible sales representa-
tive. In such a case, state a description of the defect, the type and the serial number of
the device.
Report any in-transit damage immediately. Damage reported at a later date shall not be
recognized.
Unpacking:
 Carefully unpack the unit to prevent any damage.
 Check the completeness of the delivery based on the delivery note.
Scope of delivery:
 1x VMI as ordered.
 1x Operating manual.
 1x Packaging.
∗ Customised versions available on request.
- 24 -
cata-
®
induQ
- Series VMI
© SIKA • Ba_VMI • 01/2016