Urmet Miro 1122/4 Mode D'emploi page 25

4.3 DIP-SWITCH CONFIGURATION
4.3.1 DOOR PHONE CODE
To install any "Slave" door phones, the relevant code must be set on each indoor station using DIP-switches
1 and 2.
Door phone type
Configuration not
permitted
"Slave" door phone no. 2
4.3.2 CALL BUTTON ASSOCIATION TO DOOR PHONE
Door phone associated to
the button 1 (default)
4.3.3 LINE TERMINAL
The line termination must be activated on a door phone connected at the end of a line without a new section
restarting from the LINE OUT terminals.
Terminal insert (default)
4.4 PROGRAMMING THE INTERCOM FUNCTION
The system offers the option of programming 2 buttons ( and
With Kits Ref. 1722/93 and 1722/95, it is possible to call up to 2 video door phones or door phones in the
same apartment.
With the kit Ref. 1722/94 and 1722/96 you have two calling options:
• up to 2 video door phones or door phones in the same apartment,
• 1 video door phone in the same apartment and all video door phones or door phones of the other
apartment.
4.4.1 PROGRAMMING THE FUNCTION (KIT REF. 1722/93 - /94)
To programme the buttons:
• Go to the indoor station to be programmed as caller (indoor station A).
• Press and hold for more than 5 seconds; the red LED will flash slowly and the system will emit 3
confirmation beeps to confirm the new setting.
• Press the button to be programmed as "caller" (
confirmation tone.
• Go to the indoor station to be called by that button (indoor station B) and press the door-key button. The
indoor stations A and B will emit a beep to confirm the new setting.
• To exit the programming mode, press and hold for more than 5 seconds on the indoor station A.
In any case, after 10 minutes the device will automatically quit the programming mode, saving
the edited parameters.
With the kit Ref. 1722/94, the call to a video door phone in the second apartment will
necessarily sound all video door phones in the apartment.
DS1122-013
Dip switch position
ON
1 2 3 4
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
Door phone type
"Slave" door phone no. 1
(default)
"Slave" door phone no. 3
Door phone associated to
the button 2
Terminal not inserted
) to make intercom calls.
or ) for at least 3 seconds until you hear the
Dip switch position
ON
1 2 3 4
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
25