Fox 32TC Taper-Cast Instructions D'installation page 10

REBOUND ADJUSTMENT
Rebound controls the rate of speed at which the fork extends after compressing. The rebound
adjustment is dependent on the air pressure setting. For example, higher air pressures require
slower rebound settings. Use your air pressure to find your rebound setting. The rebound adjuster is
located underneath the damper-side fork leg.
GRIP AND GRIP SL REBOUND
OPEN
(COUNTER-CLOCKWISE)
LEAST AMOUNT OF
REBOUND DAMPING,
FORK REBOUNDS
FASTEST
ADDITIONAL TUNING OPTIONS
CLIP-ON VOLUME SPACERS
Changing volume spacers in the 32 Taper-Cast fork is an easy internal adjustment that allows you to change
the amount of mid stroke and bottom out resistance. If you have set your sag correctly and are using
full travel (bottoming out) too easily, then you could install one or more spacers to increase bottom out
resistance. If you have set your sag correctly and are not using full travel, then you could remove the spacer
to decrease bottom out resistance.
Installation procedure and tuning options are available online at: ridefox.com/ownersmanuals
32 Taper-Cast Volume Spacer
Configurations
Volume Spacers
Travel Factory
Installed
50 mm
40 mm
Turn your rebound knob to the closed
position, clockwise until it stops.
Then turn it counter-clockwise to the
number of clicks shown in the table
on the previous page.
22 20 16
*Max Volume
Spacers
2 4
3 4
12 8 4
10
CLOSED
1
(CLOCKWISE)
MOST AMOUNT OF
REBOUND DAMPING,
FORK REBOUNDS
SLOWEST