How To Operate The Machine - Clarke FOCUS S28 WB Manuel D'utilisation

ENGLISH EN

HOW TO OPERATE THE MACHINE

How to Operate the One Touch System ("L Class" models only)
One touch cleaning is a feature on the new Focus Walk-behind
Scrubber. The factory defaults for this setting are two bars of brush
pressure and four bars for solution fl ow and squeegee in the down
position.
1. Press and release the green button for all cleaning functions to
begin, see fi gure #11, item A.
2. The squeegee and brush head lower to the fl oor and the vacuum
starts. NOTE: The squeegee switch must be in the center position
for the squeegee to operate with the one touch feature, see fi gure
#11, item B.
3. The brushes and solution will begin only when you begin to
traverse.
4. The cleaning will be at the factory default settings, however
you can reprogram these settings to your specifi cations. See
"Reprogramming One Touch" section below.
5. To end cleaning process, press the green button again and solution
will stop; brushes will raise; after a short delay squeegee will raise;
and the motor will turn off.
NOTE: It is intended that this be done while traversing. If you stop
and do it, some solution can be left on the fl oor.
Reprogramming One Touch
If you do not want to use the factory default settings, you may
reprogram the setting by following the procedures below:
1. Place the machine in the desired scrub condition by using the one
touch and individual switches.
2. Press and hold the green one touch button until you see the LCD
display fl ash, then release the button. NOTE: The time required
should be approximately 5 seconds.
3. When you activate or deactivate the one touch, it will now be set to
your preference for cleaning. These settings will remain until you
disconnect power or reprogram them. NOTE: When programming
one touch, be sure squeegee is in automatic (middle) position,
otherwise you may program squeegee either up or down all the
time.
How to Return One Touch to Factory Default Settings
To restore the factory settings, follow the procedures below:
1. Press and hold the green one touch button until you see the LCD
display fl ash two times (5 seconds between fl ashes), see fi gure
11. NOTE: The time required for this will be approximately 10
seconds.
2. The settings should be returned to 4 bars of solution and 2 bars of
brush pressure. NOTE: The squeegee vac switch must be in the
middle position for default settings to work.
-20- Form No. 70851A
Clarke
®
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
B
A
Figure #11