Falltech FT-R SRL Manuel De L'utilisateur page 7

3.5 Application Limits:
The SRD discussed in this manual is designed for Leading Edge applications. However, take caution to
avoid very sharp edges such as sheared metals, metals cut with an abrasive disk, or flame-cut metals.
Also take caution around very abrasive surfaces and edges, such as concrete or stone, as these edges
and surfaces may abrade the lifeline or the energy absorber during a fall event.
4.0 System Requirements
4.1 Capacity:
The SRD is designed for use by a single user with a combined weight of user, tools, clothing, etc., of
130–310 lbs (59-141 kg).
4.2 Compatibility of Connectors:
Connectors are considered to be compatible with connecting elements when they have been designed
to work together in such a way that their sizes and shapes do not cause their gate mechanisms
to inadvertently open regardless of how they become oriented. Contact FallTech if you have any
questions about compatibility. Connectors must be compatible with the anchorage or other system
components. Do not use equipment that is not compatible. Non-compatible connectors may
unintentionally disengage. Connectors must be compatible in size, shape, and strength. Self-closing,
self-locking connectors are required by ANSI and OSHA.
4.3 Compatibility of Components:
Equipment is designed for use with approved components and subsystems only. Substitutions or
replacements made with non-approved components or subsystems may jeopardize compatibility of
equipment and may affect the safetyand reliability of the complete system.
4.4 Making Connections:
Only use self-locking connectors with this equipment. Only use connectors that are suitable to each
application.Ensure all connections are compatible in size, shape, and strength. Do not use equipment
that is not compatible, see Figure 3. Visually ensure all connectors are fully closed and locked.
Connectors are designed to be used only as specified in each product's user's instructions.
4.5 Personal Fall Arrest System:
A PFAS is an assembly of components and subsystems used to arrest a person during a fall event. A
PFAS is typically composed of an anchorage and a FBH, with an energy absorbing connecting device,
i.e., an SAL, an SRD, or a Fall Arrester Connecting Subsystem (FACSS), connected to the dorsal D-ring of
the FBH. PFAS components used in conjunction with this SRD should comply with ANSI Z359, CSA Z259
requirements, and applicable OSHA regulations.
Figure 3
A
Never connect two active components (snap hooks or carabiners) to each other.
B
Never connect two active components (snap hooks or carabiners) to a single D-ring at the same time.
C
Never connect in a way that would produce a condition of loading on the gate.
7
Figure 3 - Non-Compatible Connections