Samsung DVD-V6500 Manuel D'instructions page 18

C
O N N E C T I O N S
Connection to a TV (Progressive)
1
Using component video cables (not included),
connect the COMPONENT VIDEO OUT terminal
on the rear of the DVD-VCR to the
IN terminal of your TV.
2
Using the audio cables, connect the AUDIO (red
and white) OUT terminals on the rear of the
DVD-VCR to the AUDIO (red and white) IN
terminals of your TV.
Turn on the DVD-VCR and TV.
3
With the unit in stop mode, set the Alt video
output to Component: Progressive in the Display
Setup menu (see pages 57~58) or press the
PROGRESSIVE button on the remote control
Progresive Scan mode prompt screen appears.
Then press ENTER and progressive will be
output.
4
Press the input selector on your
control until the Component signal from the
DVD-VCR appears on the TV screen.
To see the progressive video output,
- Consult your TV User's Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan
settings in the TV's menu system.
- Depending on your TV, the connection method may differ from the illustration above.
Note
What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method.
Progressive scanning method provides better and clearer picture quality.
All manuals and user guides at all-guides.com
COMPONENT
TV remote
ENG-18
White Red
Green
Red
Audio Cable
Component Cable
(not included)
Red Blue
Green
Red White
Blue