Replacement Parts; What If There Are Problems - Beurer LB 88 Mode D'emploi

Descaling the water tank
• Fill the water tank halfway with water.
• Add a small quantity of descaler.
• Tightly close the water tank using the screwed plug.
• Shake the water tank by rocking it back and forth several times.
• Empty the descaling solution completely.
• Rinse the base unit twice with clean, fresh water.
Storage
If you do not plan to use the device for a relatively long period of time, we recommend that you thoroughly
empty, clean and dry the device and store it in the original packing in a dry environment, ensuring it is not
weighed down by additional items.

9. Replacement parts

TIP!
If the water is hard, we recommend using the optional anti-limescale filter in addition to the anti-lime pads
supplied.
Anti-limescale filter (optional)
Order number 162.843. Please contact the national service address.
NOTE
• If the anti-limescale filter does not prevent limescale build-up, or if white
deposits form on or in the device, the anti-limescale filter should be replaced.
• The service life of the anti-limescale filter is around two to three months at
most.
• If the device is not used for a relatively long time, the anti-limescale filter must
be removed from the water tank and dried out.
Fitting the anti-limescale filter
• Lift the water tank and rotate it.
• Open the screwed plug on the water tank.
• Screw the anti-limescale filter onto the screwed plug on the inside.
• Tightly seal the water tank using the screwed plug.

10. What if there are problems?

Problem
The operating loop
does not light up.
No LED display.
Red LED display.
No mist is produced. The LED display lights up red.
Cause
The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
The water level is too low; the water
tank is empty.
The LED display does not light up. Connect the plug.
Solution
Turn the control dial clockwise towards the ma-
ximum position.
Turn the control dial clockwise towards the ma-
ximum position.
Fill the water tank.
Fill the water tank.
21